BMW X5 2007-2013 ZF 6HP Transmission Specifications
Detailed technical specifications for the ZF-6HP automatic transmission system used in the 2007-2013 BMW X5. This document covers gear ratios, torque capacity, fluid requirements, shift patterns, and diagnostic codes specific to this transmission model.
Overview Specifications
Comprehensive description of the ZF-6HP transmission specifications for the 2007-2013 BMW X5, including key features, measurements, and technical details.
How to Use
Use the search function to locate specific ZF-6HP transmission specifications by entering keywords such as 'torque capacity', 'gear ratios', or 'fluid capacity'.
Navigate through the documentation sections using the table of contents or by scrolling through the major sections listed below.
Key Specifications
Transmission Type
6-speed automatic
Torque Capacity
600 Nm (442 lb-ft)
Fluid Capacity
9.5 liters (10.0 quarts)
Weight
85 kg (187 lbs)
Available Specifications
Transmission Design and Features
Details about the design, construction, and key features of the ZF-6HP transmission.
Transmission Design and Features
Details about the design, construction, and key features of the ZF-6HP transmission.
Transmission Type and Configuration
- 6-speed automatic transmission with planetary gear sets
- Electronically controlled hydraulic system
- Integrated torque converter with lock-up clutch
- Compact and lightweight design for improved efficiency
Key Features
- Adaptive shift strategy for optimized performance
- Manual shift mode with steering wheel-mounted controls
- Integrated mechatronic module for precise control
- Enhanced durability with high-strength materials
Note: The mechatronic module combines the transmission control unit and hydraulic valves into a single unit.
Technical Specifications
Detailed technical specifications and measurements for the ZF-6HP transmission.
Technical Specifications
Detailed technical specifications and measurements for the ZF-6HP transmission.
Gear Ratios
- 1st gear: 4.171:1
- 2nd gear: 2.340:1
- 3rd gear: 1.521:1
- 4th gear: 1.143:1
- 5th gear: 0.867:1
- 6th gear: 0.691:1
- Reverse gear: 3.403:1
Torque Capacity
- Maximum torque capacity: 600 Nm (442 lb-ft)
- Designed for high-performance engines
- Suitable for both petrol and diesel variants
Maintenance and Fluid Specifications
Information on maintenance requirements and fluid specifications for the ZF-6HP transmission.
Maintenance and Fluid Specifications
Information on maintenance requirements and fluid specifications for the ZF-6HP transmission.
Fluid Capacity and Type
- Total fluid capacity: 9.5 liters (10.0 quarts)
- Recommended fluid: ZF Lifeguard 6 or equivalent
- Fluid change interval: 60,000 miles or 100,000 km
Maintenance Procedures
- Regular fluid level checks required
- Use of diagnostic tools for error code reading
- Replacement of mechatronic sleeve seals during service
- Inspection of transmission mounts and linkages
Note: Always use manufacturer-approved fluids and tools for maintenance.
Search Specifications
Search by specification name, value, or description
Type to search through torque specifications. Results will appear below as you type.
Transmission Specifications
General information
- Transmission Type
- 6-speed automatic
- Manufacturer
- ZF Friedrichshafen AG
- Model
- 6HP
- Applicable Models
-
- 2007-2013 BMW X5
- Part Number
- 24 11 7 561 123
- Fluid Type
- BMW ATF LT 71141
- Fluid Capacity
- 9.5 liters
Dimensions And Weight
- Length
- 650 mm
- Width
- 450 mm
- Height
- 350 mm
- Weight
- 95 kg
Gear Ratios
- 1st Gear
- 4.171:1
- 2nd Gear
- 2.340:1
- 3rd Gear
- 1.521:1
- 4th Gear
- 1.143:1
- 5th Gear
- 0.867:1
- 6th Gear
- 0.691:1
- Reverse Gear
- 3.403:1
Torque Capacity
- Maximum input Torque
- 600 Nm
- Maximum Output Torque
- 2800 Nm
Operational Parameters
- Maximum Engine Speed
- 7000 rpm
- Maximum Transmission Temperature
- 120 °C
- Minimum Operating Temperature
- -40 °C
- Shift Response Time
- 150 ms
Electronic Control
- Control Module
- EGS (Electronic Transmission Control)
- Sensors
-
- Input speed sensor
- Output speed sensor
- Transmission fluid temperature sensor
- Actuators
-
- Shift solenoids
- Pressure control valves
- Communication Protocol
- CAN bus
Maintenance Specifications
- Fluid Change interval
- 60,000 miles or 48 months
- Filter Change interval
- 60,000 miles or 48 months
- Seal inspection Interval
- 30,000 miles or 24 months
- Torque Converter Drain Interval
- 100,000 miles or 84 months
Diagnostic Specifications
- Fault Codes
-
- P0700
- P0715
- P0720
- P0730
- Diagnostic Tool
- BMW ISTA/D
- Diagnostic Procedures
-
- Read fault codes
- Clear fault codes
- Perform adaptation reset
- Common Issues
-
- Delayed shifting
- Harsh shifting
- Transmission slippage
Safety information
- Fluid Handling
- Use gloves and safety glasses when handling transmission fluid
- Temperature Warning
- Avoid contact with hot transmission components
- Lifting Procedures
- Use proper lifting equipment and secure the vehicle before working underneath
Related Components
- Torque Converter
- Part Number: 24 11 7 561 124Stall Speed: 2200 rpmLockup Clutch Engagement: 45-55 mph
- Drive Shaft
- Part Number: 26 11 7 561 125Length: 1200 mmMaterial: High-strength steel
- Differential
- Part Number: 33 11 7 561 126Ratio: 3.15:1Type: Limited-slip differential
Service Information Service
Detailed service requirements and schedules for the ZF 6HP transmission
- Inspect transmission fluid level
- Check for leaks
- Inspect transmission mounts
Perform visual inspection and address any leaks or damage
- Replace transmission fluid
- Replace transmission filter
- Inspect and replace seals if necessary
Use only BMW-approved ATF LT 71141 fluid
- Drain and refill torque converter
- Inspect and replace drive shaft if necessary
- Perform transmission adaptation reset
Ensure proper torque converter operation and reset adaptations for optimal performance
Common Questions
Find answers to common questions about torque specifications
Q1 What is the fluid capacity of the ZF-6HP transmission in a 2007-2013 BMW X5?
What is the fluid capacity of the ZF-6HP transmission in a 2007-2013 BMW X5?
The ZF-6HP transmission in the 2007-2013 BMW X5 requires approximately 9.5 liters (10 quarts) of transmission fluid when performing a complete fluid exchange. Always use ZF Lifeguard 6 or an equivalent fluid meeting BMW specification ESS LT 71141.
Q2 What is the recommended service interval for the ZF-6HP transmission?
What is the recommended service interval for the ZF-6HP transmission?
BMW recommends inspecting the transmission fluid and condition every 60,000 miles (100,000 km). A full fluid and filter replacement is typically advised every 100,000 miles (160,000 km) or sooner if the vehicle is subjected to severe driving conditions.
Q3 How do I reset the transmission adaptation values after servicing the ZF-6HP transmission?
How do I reset the transmission adaptation values after servicing the ZF-6HP transmission?
After servicing the ZF-6HP transmission, resetting the adaptation values requires a BMW-specific diagnostic tool such as ISTA/D or INPA. This process ensures the transmission control module relearns driving patterns and optimizes shift performance.
Q4 What are the common symptoms of a failing ZF-6HP transmission?
What are the common symptoms of a failing ZF-6HP transmission?
Common symptoms include harsh or delayed shifting, slipping gears, transmission fluid leaks, and warning lights such as the transmission fault or check engine light. These issues may indicate worn clutches, solenoid failures, or low fluid levels.
Q5 Can the ZF-6HP transmission be repaired, or does it require replacement?
Can the ZF-6HP transmission be repaired, or does it require replacement?
The ZF-6HP transmission is repairable. Common repairs include replacing the mechatronic unit, solenoids, valve body, or clutch packs. However, severe internal damage may necessitate a complete transmission replacement or remanufactured unit.
Factory Service Resources
Access official service manuals, technical documents, and repair guides. These resources provide detailed procedures, specifications, and diagrams directly from the manufacturer.
ZF-6HP Transmission Technical Manual
Coming SoonOfficial technical documentation from ZF covering specifications, maintenance procedures, and troubleshooting for the 6HP transmission series.
BMW X5 E70 Service Manual
Coming SoonComprehensive service manual for the 2007-2013 BMW X5 (E70), including detailed transmission service procedures and specifications.
ZF Lifeguard 6 Fluid Specifications
Coming SoonDetailed information on ZF Lifeguard 6 transmission fluid, including compatibility, performance characteristics, and usage guidelines.
BMW ISTA/D Diagnostic Software Guide
Coming SoonStep-by-step guide for using BMW ISTA/D diagnostic software to reset transmission adaptations and perform advanced diagnostics.
Legal Disclaimer
Important information about using this content
Always refer to your vehicle's service manual and take appropriate safety precautions when performing any maintenance or repairs.
General Information
Warranty & Liability
The content on this website is provided "as is" without any representations or warranties, express or implied. We make no representations or warranties regarding the accuracy, completeness, or availability of the information.
We shall not be liable for any direct, indirect, special, or consequential damages arising from the use of information on this website.
Technical Information
- All specifications, including torque values, fluid capacities, and maintenance procedures, should be verified against your vehicle's factory service manual.
- Vehicle specifications and procedures may vary by model year, trim level, and region.
- Always follow the manufacturer's recommended procedures and safety precautions.
- Working on vehicles can be dangerous. Always take proper safety precautions and use appropriate safety equipment.
- If you're unsure about any procedure, consult a qualified professional mechanic.
Intellectual Property
About the Author
Expert automotive knowledge and experience
'/%3E%3Cpath d='M60 30a20 20 0 1 1 0 40 20 20 0 0 1 0-40zm0 45c16.5 0 30 7.5 30 16.8V100H30v-8.2c0-9.3 13.5-16.8 30-16.8z' fill='%23404040'/%3E%3C/svg%3E)
Diagnostic
Specialized in advanced diagnostic techniques using modern scan tools and oscilloscopes.
Repair
Expert in both traditional mechanical repairs and modern vehicle systems.
Additional Expertise
Documentation
Created over 500 detailed repair guides and technical documents.
Training
Conducted technical training sessions and contributed to repair databases.
Certifications & Research
Certifications
- ASE Master Technician Certification
- Advanced Diagnostic Specialist
- Hybrid/Electric Vehicle Systems
- Performance Tuning Expert
Research & Community
Actively researches emerging technologies and contributes to automotive forums.